I was trying to programming a KB9012 one LA-8531P, and it was allways giving the error 3.0.0.
After a while the programmer goes off and it became to smell very badly.
When i was looking closing....i see this resistor (R2R right?) bruned!
Now when i connect the programmer i have to give some press on the resistor to detect by system! But if i connect the Keyboard module i have no signal of that and the Programmer goes off. Sometimes the lighs from Keyboard module became to flash at a very low.
The question is....can it be a resistor problem? can i change without louse waranty?
Thanks in advance!
2 сообщения • Страница 1 из 1
Кто сейчас на конференции
Сейчас этот форум просматривают: нет зарегистрированных пользователей и 1 гость