I replaced the KBC IT8226E-BXA 128 for the new one on the MOBO NM-B701, but I have got the problem with programming it. The SVOD3 detects it, reads it but can't erase and program it.
This is the log from program:
When I push WRITE the process is proceeding correctly until to VERIFY and then it stops and shows the verify error."ITE mode selected
check pins ok
selected motherboard NM-B701
CHECK GND
Now plug power to the motherboard
Device ID: 8226
Device Revision: 1
ITE series detected
Flash ID: FFFFFE
Status reg: FFFFFE
When I only try to erase KBC, the process is proceeding correctly but when I read KBC again, the program is still there.
Can you help me to solve this problem?
What does the "Status reg: FFFFFE" mean?